Home

Where to buy

Support

Contact us

 

Discontinued Products

  • BMW K1200LT LED Tail and Brake Light Kit (for license plate holder)
    The LED Tail and Brake light kit contains everything you need to add a high-visibility combination tail and brake light to the license plate holder of your K1200LT (the license plate is moved down to make room for the LED taillight). Click here for the installation instructions.

  • Interior Saddlebag LED or Trunk Extension Light for BMW K1200LT
    This kit can be mounted inside either the saddlebags or the trunk to light up the interior space; it comes with a 15' cord so it can also be used as an extension light anywhere around your bike. Click here for the installation instructions.

  • Reflective Tape Kits
    Availabe for the BMW K1200LT and Unigo trailers. The black reflective tape that glows bright white when light strikes it; this kit greatly increases the conspicuity of your bike at night. Click here K1200LT instructions and here for Unigo instructions.

  • Embedded LED in the Tip-Over Wings for BMW K1200LT
    This kit adds 5 red and 9 amber LEDs to each Tip-Over wing (8 amber if you have J-Pegs installed). The LEDs are installed and soldered from the inside of the Tip-Over wing cover and act as both running lights and turn signals, making it easier for other vehicles to see the side of your bike and your intention to turn or change lanes. Click here for the installation instructions.

  • Saddlebag Reflector Kit for BMW K1200LT
    The LED Saddlebag Reflector kit contains everything you need to replace your factory reflectors with LED reflectors that act as both turn signals and running lights. We even pay cash if you send us your old reflectors! Click here for the installation instructions.

  • Tip-Over Wing LED Marker Light Kit
    This kit adds an amber side marker light to the rectangular indentation on the chrome covers of the tip-over wings (near the rider's feet). The marker light acts as both a running light and turn signal, making it easier for other vehicles to see the side of your bike and your intention to turn or change lanes. Very easy to install. Click here for the installation instructions.

  • Mick-O-Peg (Model K12O and Model K12N) LED Marker Light Kit (for BMW K1200LT)
    This kit adds an amber side marker light to the flat section of the bar near the hinge. The marker light acts as both a running light and turn signal, making it easier for other vehicles to see the side of your bike and your intention to turn or change lanes. Easy to install. Click here for the installation instructions.

  • Trunk Mounted Taillight and Turn Signal LED Strips
    (for BMW K1200LT)

    This kit adds three LED strips to your trunk, just below the lid. The upper strip goes all the way around the three visible sides and acts like a red running light. The two lower strips (they meet at the center of the trunk) act as left and right amber turn signals. The LED strips stick on with adhesive—the wires run under the passenger seat and trunk to the taillight area. Click here for the installation instructions.

  • Tip-Over Wing LED Strip (for BMW K1200LT)
    This kit adds 15 amber LEDs to each Tip-Over wing. The LEDs come pre-installed on a thin 30 cm long black strip. To install the LEDs you just drill one hole, peal off the backing, and stick on the strip. The LEDs act as both running lights and turn signals, making it easier for other vehicles to see the side of your bike and your intention to turn or change lanes.Click here for the installation instructions.

View our current-product brochure here.